A modelling approach to formally represent service
orchestration
DOI: 10.1504/IJCAET.2008.021253 | Corina Popescu, Andrei Lobov, Jose L. Martinez Lastra, Maria De Los Angeles Cavia Soto | This paper presents a methodology to formally model service orchestration. The methodology is based on a set of selected flow descriptors, which are expressed in a Petri net derived formalism. The chosen descriptors cover concurrency, synch... | 1 - 30 |
ANSYS and LS-DYNA used for structural analysis
DOI: 10.1504/IJCAET.2008.021253 | Yucheng Liu | This paper discusses the different features of ANSYS and LS-DYNA in solving structural analysis using finite element approach. ANSYS and LS-DYNA are two popular engineering software tools that are used for finite element analysis. The diffe... | 31 - 44 |
Heuristic algorithm to optimise the manufacturing system design to get maximum profit
DOI: 10.1504/IJCAET.2008.021253 | Shishir Bhat | Agile manufacturing has become a topic of great interest over the past several years. The entire domain of modelling and analysing different types of agile manufacturing environments and systems, however, remain largely unexplored. The obje... | 45 - 64 |
Kinematics/statics analysis of some limited-dof parallel manipulators by a block diagram modelling system
DOI: 10.1504/IJCAET.2008.021253 | Yi Lu, Bo Hu | A block diagram modelling system is proposed for analysing kinematics and statics of limited-dof parallel manipulators (PMs) in SimMechanics. First, some common modelling and simulation techniques of block diagram modelling system are descr... | 65 - 80 |
Improving ID performance using GA and NN
DOI: 10.1504/IJCAET.2008.021253 | S. Selvakani, R.S. Rajesh | The internet has been growing at an amazing rate and concurrent with the growth, the vulnerability is also increasing. How to find and detect novel or unknown attacks is one of the most important objectives in current IDS. Most of the curre... | 81 - 93 |
Current distribution and neck growth during spark plasma sintering conductive powder
DOI: 10.1504/IJCAET.2008.021253 | Xuemei Liu, Xiaoyan Song, Jiuxing Zhang | The evolution of the sintering neck sizes was observed in experiments on the conductive powder particles, based on which a model that describes the distributions of the current density and the temperature increase in the spark plasma sinter... | 94 - 104 |
Numerical slicing and optimum hatching of parametric B-Rep solids in layered manufacturing
DOI: 10.1504/IJCAET.2008.021253 | Regalla Srinivasa Prakash, Arnab Jyothi Ghosh, Amit Kumar Singh, P.K. Pakala, P.V.M. Rao | In this paper, numerical slicing of parametric B-Rep solids has been proposed based on the concepts of virtual cloud points and Delaunay triangulation for the purpose of layered manufacturing. The layer geometry thus obtained readily lent i... | 105 - 124 |
