Pages | Title and author(s) |
135-154 | Predictive modelling of average heat partition in high speed machining of AISI/SAE 4140 steelF. Akbar, P.T. Mativenga, M.A. Sheikh DOI: 10.1504/IJMMM.2009.023388 |
155-175 | A multi-linear cutting modelJean-Yves K'nevez, Olivier Cahuc, Sylvain Laporte, Philippe Darnis DOI: 10.1504/IJMMM.2009.023389 |
176-206 | Analytical modelling of cutting phenomena improvements with a view to drilling modellingF. Dargnat, Ph. Darnis, O. Cahuc DOI: 10.1504/IJMMM.2009.023390 |
207-231 | Neural network based prediction of drill wear from theoretically analysed and experimentally measured values of thrust force and torqueKarali Patra, Kingshook Bhattacharyya, Surjya K. Pal DOI: 10.1504/IJMMM.2009.023391 |
232-244 | Fundamental performance of magnetic compound fluid (MCF) polishing tool in metal surface finishingYongbo Wu, Kunio Shimada, Yat Choy Wong DOI: 10.1504/IJMMM.2009.023392 |
245-267 | Microgrinding of flat surfaces on single-disc lapping machineAdam Barylski, Mariusz Deja DOI: 10.1504/IJMMM.2009.023393 |
268-277 | Surface and topographical parameters investigation at abrasive waterjet machining by means of optical measurementJan Valicek, Milena Kusnerova, Sergej Hloch, Katarina Monkova DOI: 10.1504/IJMMM.2009.023394 |
278-289 | Machined surface image analysis when turning with modified cutting pointsAnna Zawada-Tomkiewicz, Borys Storch DOI: 10.1504/IJMMM.2009.023395 |
290-307 | Method for the evaluation of the materials machinability by electrical discharge machiningLaurentiu Slatineanu, Margareta Coteata, Oana Dodun, Dan Adrian Anton DOI: 10.1504/IJMMM.2009.023396 |
308-320 | Enhancing the performance of electrical-discharge machining via various planetary modesT.A. El-Taweel, M.S. Hewidy DOI: 10.1504/IJMMM.2009.023397 |
321-346 | Roughness modelling and optimisation in EDM using response surface method for different work piece materialsP. Sahoo, B.C. Routara, A. Bandyopadhyay DOI: 10.1504/IJMMM.2009.023398 |
347-366 | An investigation into the effect of work material properties, tool geometry and abrasive properties on performance indices of ultrasonic machiningJatinder Kumar, J.S. Khamba DOI: 10.1504/IJMMM.2009.023399 |
367-368 | Book Review: Tribology of Metal Cutting by Viktor P. AstakhovJ. Paulo Davim DOI: 10.1504/IJMMM.2009.023400 |
369-370 | Book Review: Advanced Machining Processes of Metallic Materials by Wit GrzesikJ. Paulo Davim DOI: 10.1504/IJMMM.2009.023401 |