
International Journal of Machining and Machinability of Materials
2006 Vol.1 No.4
Special Issue on Advances in Machining of Composites Materials
Guest Editor: Dr. J. Paulo Davim
Pages | Title and author(s) |
380-395 | Parametric study and optimisation of wire electrical discharge machining of Al-Cu-TiC-Si P/M compositeTaha Ali El-Taweel DOI: 10.1504/IJMMM.2006.012348 |
396-411 | An experimental study of the machining parameters in powder mixed electric discharge machining of Al–10%SiCP metal matrix compositesH.K. Kansal, Sehijpal Singh, Pradeep Kumar DOI: 10.1504/IJMMM.2006.012349 |
412-431 | Some investigations into wire electro-discharge machining performance of Al/SiCp compositesN.G. Patil, P.K. Brahmankar DOI: 10.1504/IJMMM.2006.012350 |
432-444 | Nd:YAG laser micromachining of alumina–aluminium interpenetrating phase composite using response surface methodologyA.S. Kuar, G. Paul, S. Mitra DOI: 10.1504/IJMMM.2006.012351 |
445-462 | Optimisation of MRR in ultrasonic drilling (USD) based on Taguchi's robust design methodologyR.S. Jadoun, Pradeep Kumar, B.K. Mishra, R.C.S. Mehta DOI: 10.1504/IJMMM.2006.012352 |
463-475 | A study on machinability of Al Si7 Mg2/SiCp metal matrix compositeErol Kilickap, Ali Inan DOI: 10.1504/IJMMM.2006.012353 |
476-487 | Optimisation of surface roughness with GA approach in turning 15% SiCp reinforced AlSi7Mg2 MMC materialCihan Ozel, Erol Kilickap DOI: 10.1504/IJMMM.2006.012354 |
488-499 | Taguchi method based optimization of cutting tool flank wear during turning of PR-Al/20vol.% SiC-MMCAlakesh Manna, Bijay Bhattacharyya DOI: 10.1504/IJMMM.2006.012355 |
500-510 | Analysis of burr formation during drilling of hybrid metal matrix composites using design of experimentsS. Basavarajappa, G. Chandramohan, M. Ashwin, M. Prabu, K. Mukund DOI: 10.1504/IJMMM.2006.012356 |