Browse issues Vol. 7 2018 Vol. 7 No. 2/3 2018 Vol. 7 No. 1 Vol. 6 2017 Vol. 6 No. 4 2017 Vol. 6 No. 2/3 2016 Vol. 6 No. 1 Vol. 5 2015 Vol. 5 No. 3/4 2015 Vol. 5 No. 2 2015 Vol. 5 No. 1 Vol. 4 2014 Vol. 4 No. 2/3/4 2014 Vol. 4 No. 1 Vol. 3 2013 Vol. 3 No. 4 2013 Vol. 3 No. 2/3 2012 Vol. 3 No. 1 Vol. 2 2011 Vol. 2 No. 4 2011 Vol. 2 No. 3 2011 Vol. 2 No. 1/2 Vol. 1 2010 Vol. 1 No. 4 2010 Vol. 1 No. 3 2009 Vol. 1 No. 2 2009 Vol. 1 No. 1 International Journal of Rapid Manufacturing2015 Vol. 5 No. 2 PagesTitle and authors129-144An independent CAPP system for prismatic partsAwais Ahmad Khan; Emad Abouel Nasr; Abdulrahman Al-Ahmari DOI: 10.1504/IJRAPIDM.2015.073556145-154A simplified benchmarking model for the assessment of dimensional accuracy in FDM processesNathan Decker; Albert YeeDOI: 10.1504/IJRAPIDM.2015.073573155-169Process capability analysis of three dimensional printing as cost-effective rapid casting solution for low melting alloysKamaljit Singh Boparai; Rupinder Singh; Harwinder SinghDOI: 10.1504/IJRAPIDM.2015.073574170-185The development of a framework between the 3D printed patterns and sand-cast work piecesTaylor Fresques; Derrick Cantrell; Ismail FidanDOI: 10.1504/IJRAPIDM.2015.073575186-198Effect of fractal curve based toolpath on part strength in fused deposition modellingNarendra Kumar; Saquib Shaikh; Prashant K. Jain; Puneet TandonDOI: 10.1504/IJRAPIDM.2015.073576199-212The future for design education: preparing the design workforce for additive manufacturingJennifer LoyDOI: 10.1504/IJRAPIDM.2015.073577
