Identification of the tribological processes on the grinding wheel surface during the internal cylindrical grinding of 100Cr6 steel, based on SEM-EDS analysis Online publication date: Tue, 28-Jul-2015
by Krzysztof Nadolny; Wojciech Kapłonek
International Journal of Surface Science and Engineering (IJSURFSE), Vol. 9, No. 4, 2015
Abstract: In the paper, energy dispersive X-ray spectroscopy (EDS) and scanning electron microscopy (SEM) are used in the assessment of the grinding wheel active surface (GWAS). The analysis of the processes of wear and the phenomena that cause them, are also presented and discussed. The experimental investigations were carried out on a grinding wheel made from microcrystalline sintered corundum grains after the process of plunge grinding of the workpiece made from steel 100Cr6. The high efficiency of the proposed methods was noted, which has given a reliable indication of the tribological phenomena taking place in the area of contact between grinding wheel and workpiece. Therefore, it allows for improvement of the machining conditions or modification of the grinding wheel construction.
Online publication date: Tue, 28-Jul-2015
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Surface Science and Engineering (IJSURFSE):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email firstname.lastname@example.org