Calls for papers
International Journal of Rapid Manufacturing
Special Issue on: "Modelling and Analysis Tools for Digital Manufacturing"
Ali K. Kamrani, University of Houston, USA
Advancement in the design and application of digital manufacturing is an indication of the next industrial revolution. Digital manufacturing (DM) uses additive manufacturing (AM) and fabrication technologies to produce complex and high-value products.
The broad impacts of AM are significant. Engineering tools such as simulation, FEA, dynamic systems modelling and control systems are just some of the tools used in DM technology.
The aim of this special issue is the publication of recent articles related to the advancement of AM and its impact on DM.Subject Coverage
Suitable topics include, but are not limited to, the following:
- Optimum planning of powder and recycled powder usage
- Materials simulation modelling for prediction of properties and performance
- Integrated additive and subtractive process planning
- AM process modelling and dynamic systems analysis
- AM parameter predictions and impact analysis
- Process control using sensors and closed-loop systems
Notes for Prospective Authors
Submitted papers should not have been previously published nor be currently under consideration for publication elsewhere. (N.B. Conference papers may only be submitted if the paper has been completely re-written and if appropriate written permissions have been obtained from any copyright holders of the original paper).
All papers are refereed through a peer review process.
All papers must be submitted online. To submit a paper, please read our Submitting articles page.
Full paper submission: 30 March, 2015
Notification of review results: 31 May, 2015
Revised manuscript submission: 1 July, 2015
Final accepted paper submission: 31 August, 2015