Rotordynamic analysis of machines on active magnetic bearings: comparison to fluid film bearing machines and vibration specifications Online publication date: Mon, 13-Jul-2009
by Paul E. Allaire, Timothy W. Dimond, Zongli Lin
International Journal of Modelling, Identification and Control (IJMIC), Vol. 7, No. 1, 2009
Abstract: This article considers rotordynamic modelling of a flexible rotor supported on active magnetic bearings (AMBs) and compares the process to a similar process for fluid film bearings (FFBs). Currently, vibration specification standards are good for industrial FFB supported rotors but are not adequate for active magnetic bearing supported rotors. This article discusses comparative studies of rotors on AMBs and FFBs involving critical speeds, AMB and FFB stiffness and damping values, mode shapes, and forced response. One objective is to assist in better communication between mechanical engineers who typically design and operate industrial machines and controls and engineers (usually electrical engineers) who design and produce AMBs. The stability of AMB machines subject to internal cross-coupled stiffness such as in seals is not considered in this work, except for the introduction.
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Modelling, Identification and Control (IJMIC):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email subs@inderscience.com