Evaluation of the residual stresses and corrosion resistance of shot-peened 7075 aluminium alloy under different states Online publication date: Thu, 22-Sep-2016
by Sebastjan Žagar; Janez Grum
International Journal of Materials and Product Technology (IJMPT), Vol. 53, No. 3/4, 2016
Abstract: This paper investigates the effect of pitting corrosion and residual stresses on different shot-peened ENAW 7075 aluminium alloys under different states. The objective of the research was to establish the parameters of the shot peening treatment of the aluminium alloy in different precipitation-hardened states concerning residual stress profiles and corrosion resistance. The experimental characterisation is primarily based on the evaluation of the residual stress profiles caused by shot-peening treatments and on the measurement of corrosion potentials as well as of cyclic polarisation curves in an NaCl solution for different material conditions. The obtained results show a favourable influence of shot peening treatment on induced compressive residual that retarded the initiation of fatigue cracks. The analysis also indicated that particles such as Al7Cu2Fe and MgZn2 play an important role in pitting corrosion and that the numbers and sizes of surface pits were reduced after shot peening.
Online publication date: Thu, 22-Sep-2016
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Materials and Product Technology (IJMPT):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email firstname.lastname@example.org