Characterisation of submicron size entrainment in the aqueous product stream of a 40 mm diameter centrifugal extractor for 30% tbp/nitric acid biphasic system Online publication date: Fri, 24-Oct-2014
by Shekhar Kumar; Rajendra Singh Shekhawat; Abhishek Singh; M. Balamurugan; N. Priyadarshini; M. Sampath; U. Kamachi Mudali
International Journal of Nuclear Energy Science and Technology (IJNEST), Vol. 8, No. 1, 2014
Abstract: Annular centrifugal extractor is a favoured solvent extraction contactor where process flowsheet requires a low hold-up, lower residence times and compact layout. However during operation of annular centrifugal extractor, a small entrainment, generally of the order of few hundred ppm, is always observed. To characterise this small entrainment, hydrodynamic experiments in a no-mass transfer mode were conducted on a 40 mm centrifugal extractor with 30%TBP/dodecane and acidified water. The aqueous product stream was analysed by dynamic light scattering based methods and drop size distribution was experimentally measured. The maximum entrained micro-drop size was typically below 1 μm in most of the cases and in the rest it was well below 10 μm. Thus the original assertion, that small entrainment occurred due to micro-sized drops, was proved right. However due to complex relations of peak locations and relative peak intensities to the physical and operating properties of solvent extraction system, mathematical modelling or correlation of experimental results was not feasible.
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Nuclear Energy Science and Technology (IJNEST):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email subs@inderscience.com