Dimensional precision and surface roughness on
turning tubes in fibre reinforced plastics based on the design experiments Online publication date: Mon, 10-May-2004
by J. Paulo Davim, Pedro Reis
International Journal of Materials and Product Technology (IJMPT), Vol. 20, No. 4, 2004
Abstract: This paper presents a study of the cutting parameters (cutting velocity and feed) on dimensional precision and surface roughness in turning tubes of fibre reinforced plastics (FRP). A plan of experiments, based on the techniques of Taguchi, was performed machining with cutting parameters prefixed in composite workpiece. An orthogonal array and the analysis of variance (ANOVA) are employed to investigate the cutting characteristics of FRP (glass fibre-reinforced filament-wound tubes) using cemented carbide (K15) cutting tools. The objective was to establish a correlation between cutting velocity and feed with the surface roughness and the international dimensional precision (IT) in composite workpiece. The correlation was obtained by multiple linear regression. Finally, confirmation tests were performed to make a comparison between the experimental results foreseen from the mentioned correlation.
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Materials and Product Technology (IJMPT):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email subs@inderscience.com