A multifunctional high-speed spindle for micromachining medical materials
by Mark J. Jackson, Chengying Xu, Waqar Ahmed
International Journal of Nano and Biomaterials (IJNBM), Vol. 2, No. 6, 2009

Abstract: The efficiency of micro cutting tools that are used in high-speed air turbine spindles depends on the rotational speed of the rotor, especially when machining medical materials such as titanium alloys. A high-pressure variation on the surface of the rotor causes the rotor to retard and this severely limits the reliability and durability of high-speed spindles to support new developments in the developing area of micromachining. A variety of spindle designs are proposed and numerical simulations carried out for each design using FLUENT software. The results revealed that changes in the rotor, inlet and outlet geometries affect the pressure distribution on the rotor significantly. The optimum design was identified based on the lowest pressure variation on the rotor surface obtained from the FLUENT results. Spinning the rotor at very high speeds provides a new direction in the development of mechanical micromachining.

Online publication date: Wed, 16-Sep-2009

The full text of this article is only available to individual subscribers or to users at subscribing institutions.

 
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.

Pay per view:
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.

Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Nano and Biomaterials (IJNBM):
Login with your Inderscience username and password:

Username:        Password:          Forgotten your password?

Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.

If you still need assistance, please email subs@inderscience.com