A combined analysis of heat conduction, contact pressure and transient vibration of a disk brake Online publication date: Wed, 15-Jul-2009
by Huajiang Ouyang, Abd Rahim Abu-Bakar, Lijie Li
International Journal of Vehicle Design (IJVD), Vol. 51, No. 1/2, 2009
Abstract: This paper studies car disc brake squeal by transient analysis and details the first attempt to combine heat conduction analysis, contact analysis and transient analysis of disc brake squeal. The contact pressure at the disc/pads interface is first computed, and the information is used to define friction-induced heat flux. Its resultant heat conduction is then analysed. Finally, transient analysis is performed, considering the influence on squeal generation of contact pressure distribution affected by brake pad surface roughness and thermal deformation. A noticeable difference is found between the dynamic responses obtained with the thermal effect from those without the thermal effect.
Online publication date: Wed, 15-Jul-2009
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Vehicle Design (IJVD):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email email@example.com