An experimental study of laser cutting of PLA-wood flour 3D printed plates using a modified Taguchi design Online publication date: Thu, 01-Jun-2023
by John D. Kechagias; Konstantinos Ninikas; Konstantinos Salonitis
International Journal of Experimental Design and Process Optimisation (IJEDPO), Vol. 7, No. 1, 2022
Abstract: Wooden powder flour blended with thermoplastic polylactic acid (WPLA) is an eco-friendly composite material used in filament material extrusion (MEX) additive manufacturing (AM). This work investigates the effect of CO2 laser cutting (LC) of filament MEX WPLA thin plates with variable cutting parameters on mean kerf width (Wm) and means surface roughness (Ra). The experimental design consists of three parameters with three levels each, i.e., the beam cutting direction (CD: 0, 45, 90°), the cutting speed (CS: 8, 13, 18 mm/s), and the beam power (BP: 82.5, 90, 97.5 W). Eleven experiments were performed following the Taguchi L9 orthogonal array plus two in the central point. Finally, additional combinations were run and validated the suggested modified Taguchi design resulting in acceptable mean average percentage errors (MAPE). The optimum parameters' values combination (90° CD, 18mm/s CS and 97.5W BP) results in about 8.44 μm Ra and 0.355 mm Wm.
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Experimental Design and Process Optimisation (IJEDPO):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email subs@inderscience.com
Our Blog 
Follow us on Twitter 
Visit us on Facebook