The effect of geometry on tensile strength of biodegradable polylactic-acid tensile-test specimens by material extrusion
by Alper Ekinci; Andrew A. Johnson; Andrew Gleadall; Xiaoxiao Han
International Journal of Rapid Manufacturing (IJRAPIDM), Vol. 10, No. 1, 2021

Abstract: Biodegradable polylactic acid-based polymers are the most common material that can be manufactured using material extrusion, one of the most widely known additive manufacturing methods. However, medical grade polymers are too expensive for degradation studies with common tensile specimens. Therefore, this paper aims to reduce the volume of the material used for manufacturing tensile specimens by introducing a new micro-X tensile specimen developed for steel. The tensile strength of micro-X tensile specimens were compared with the ASTM D1708 standard tensile specimens. Experimental results and statistical analysis showed that there was no significant difference in terms of tensile strength. Furthermore, the micro-X tensile specimen reduced the volume and as well as the cost to 1% in comparison to ASTM D638 type V standard tensile specimens.

Online publication date: Tue, 04-Jan-2022

The full text of this article is only available to individual subscribers or to users at subscribing institutions.

Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.

Pay per view:
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.

Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Rapid Manufacturing (IJRAPIDM):
Login with your Inderscience username and password:

    Username:        Password:         

Forgotten your password?

Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.

If you still need assistance, please email