Study of tool dynamics with a discrete model of workpiece in orthogonal turning Online publication date: Sun, 26-Jun-2011
by K. Rama Kotaiah, J. Srinivas
International Journal of Machining and Machinability of Materials (IJMMM), Vol. 10, No. 1/2, 2011
Abstract: This paper proposes a realistic analytical stability model of regenerative chatter in orthogonal turning operation. Tool geometry is initially developed as a solid model and analysed at different tool overhang conditions. In each case, stiffness, fundamental bending mode and corresponding damping ratios of the tool are evaluated. With this data, cutting tool can be represented with a lumped parameter single-degree of freedom vibration oscillator. Workpiece dynamics on the other hand is considered independently using a discrete finite element beam model. At some contact node of the workpiece, tool mass imposes a regenerative cutting force and second order dynamic delay differential equations are formulated in terms of tool and modal parameters. Stability criterion is formulated from characteristic equation. The effects of tool-overhang and work cross-section on the stability from the proposed model are reported. Results are illustrated with a commonly used HSS cutting tool with tailstock-supported workpiece. Experimental analysis is carried out to show the effect of tool-overhang on cutting dynamics.
Online publication date: Sun, 26-Jun-2011
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Machining and Machinability of Materials (IJMMM):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email firstname.lastname@example.org