Title: Application of masking technique in EDM for generation of rectangular shaped pattern

Authors: Maneswar Rahang; Promod Kumar Patowari

Addresses: Department of Mechanical Engineering, National Institute of Technology Silchar, P.O. Silchar – 788010, Assam, India ' Department of Mechanical Engineering, National Institute of Technology Silchar, P.O. Silchar – 788010, Assam, India

Abstract: This paper presents a novel application of masking technique for pattern generation in electric discharge machining (EDM). The experimental study was carried out to explore the capability of pattern generation using shaped masking and simple flat end tool electrode without any pattern on it. Powder metallurgical (P/M) green compacts of composition 75%W-25%Cu were used as tools and aluminium as work material. Powder materials were deposited at pre-defined area of work surface to generate some rectangular block pattern. Deviation from pre-defined boundary line was observed to analyse the geometric dimensional accuracy. Experimental results showed that compact load plays very important role followed by peak current (I_p) and pulse on-time (T_on) over the surface roughness and edge roughness of the pattern. At optimum condition, surface roughness was found to be 3.17 µm and edge roughness to be 6.42 µm. SEM, EDS and XRD analyses confirmed tool material transfer to pre-defined area.

Keywords: EDM; electrical discharge machining; shaped masking; aluminium; deposition; surface; electro-discharge machining; rectangular patterns; pattern generation; powder metallurgy; green compacts; compact load; peak current; pulse on-time; surface roughness; edge roughness.

DOI: 10.1504/IJPTECH.2015.070639

International Journal of Precision Technology, 2015 Vol.5 No.2, pp.140 - 156

Received: 06 Oct 2014
Accepted: 16 Apr 2015
Published online: 15 Jul 2015 *

Full-text access for editors Full-text access for subscribers Purchase this article Comment on this article