Title: Cutting forces measurements during discontinuous machining process
Authors: B. Benmohammed
Addresses: Faculty of Technology, Mechanical Engineering Department, University of Batna, 01 Avenue Boukhlouf Mohamed El Hadi, Batna, 05000, Algeria
Abstract: He presents the various cases where the measurement of cutting forces in fast transitory mode is necessary. He exposes also a method of compensation of inertial effects which denatures the signals provided by the most used piezoelectric dynamometers. The possibilities of this method, based on the accelerations measurements of the upper part of the dynamometer, are exposed for the case of a discontinuous turning process. It is shown that the undesirable effects related to the resonance frequencies of the dynamometer and to its base movements are mainly eliminated.
Keywords: force compensation; inertial forces; cutting forces; force measurement; discontinuous machining; discontinuous turning; piezoelectric dynamometers.
DOI: 10.1504/IJMMM.2012.048552
International Journal of Machining and Machinability of Materials, 2012 Vol.12 No.1/2, pp.3 - 13
Received: 28 Mar 2011
Accepted: 26 Nov 2011
Published online: 23 Aug 2014 *