Title: Limit load evaluation of hydraulic actuators

Authors: S. Baragetti, A. Terranova

Addresses: Dip.to Meccanica, Politecnico di Milano, Piazza L. da Vinci, 32, 20133 Milano, Italy. ' Dip.to Meccanica, Politecnico di Milano, Piazza L. da Vinci, 32, 20133 Milano, Italy

Abstract: Hydraulic actuators are employed in many fields of mechanical and civil engineering because of their low cost and high reliability. Notwithstanding their diffusion, the structural behaviour of the hydraulic actuators seems not to be well understood and the limit buckling load is determined by neglecting the effects induced by friction at the restrained ends, clearance in correspondence of the connection of the rod with the cylinder and rectilinear imperfections. The object of this paper is to investigate the effects caused by friction and clearance in the connection between the rod and the cylinder for hydraulic actuators of the |plunger rod| kind. Friction at the restrained ends, for the pin connected ends case, is also evaluated.

Keywords: analytical modelling; buckling loads; experimental procedures; friction; hydraulic actuators; limit load; rectilinear imperfections; load evaluation; connection clearance; plunger rod.

DOI: 10.1504/IJMPT.1999.036260

International Journal of Materials and Product Technology, 1999 Vol.14 No.1, pp.50 - 73

Published online: 01 Nov 2010 *

Full-text access for editors Full-text access for subscribers Purchase this article Comment on this article