Precision hole making on laminate composite: a tool wear analysis and comparison between drilling and punching
by N.A. Ghaffar; A.B. Abdullah; Z. Samad
International Journal of Materials Engineering Innovation (IJMATEI), Vol. 7, No. 2, 2016

Abstract: Hole precision is highly critical for accurate and strong fastener assembly. This factor is considerably important for structural materials, such as composite materials. Drilling is the most commonly used process for producing holes on composites. However, drilling causes excessive tool wear, which may affect the quality of holes and result in damage, such as delamination. The main objective of this study is to compare the drilling and punching processes in terms of tool wear by using the focus variation technique. The scanned images of both the puncher and drill bits are obtained by using a 3D optical surface measurement device called Alicona IFM. Tool wear patterns from both drilling and punching are analysed and compared, and the effects of the processes on the quality of the produced holes are observed.

Online publication date: Sun, 02-Oct-2016

The full text of this article is only available to individual subscribers or to users at subscribing institutions.

 
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.

Pay per view:
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.

Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Materials Engineering Innovation (IJMATEI):
Login with your Inderscience username and password:

Username:        Password:          Forgotten your password?

Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.

If you still need assistance, please email subs@inderscience.com