Experimental investigation on drilling of borosilicate glass using micro-USM with and without tool rotation: a comparative study
by Sandeep Kumar; Akshay Dvivedi
International Journal of Additive and Subtractive Materials Manufacturing (IJASMM), Vol. 1, No. 3/4, 2017

Abstract: The application of microproducts is increasing rapidly in various fields such as automobiles, electronics, microfluidics, bio-MEMS, etc. These microproducts are generally made of hard and brittle materials, e.g., glass, quartz, ceramics and silicon, etc. The machining of these materials in micro-domain is a difficult task. Micro-ultrasonic machining (micro-USM) is a preferred process for machining of hard and brittle materials. But high tool wear and low aspect ratios limits its industrial use. This investigation compares the effect of tool rotation on material removal rate and hole overcut. Additionally, aspect ratio was measured. The variable process parameters for the investigation were power rating, static load, slurry concentration and abrasive size. Imaging was used for qualitative analysis of tool wear. The experimental results reveal that micro-USM with tool rotation resulted in higher material removal rate, lesser hole overcut, high aspect ratios and lesser tool wear in compared with micro-USM without tool rotation.

Online publication date: Sun, 25-Feb-2018

The full text of this article is only available to individual subscribers or to users at subscribing institutions.

 
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.

Pay per view:
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.

Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Additive and Subtractive Materials Manufacturing (IJASMM):
Login with your Inderscience username and password:

    Username:        Password:         

Forgotten your password?


Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.

If you still need assistance, please email subs@inderscience.com