The dependence of the ploughing forces on the cutting speed Online publication date: Tue, 10-May-2022
by Alexey Popov; Iuliia Krasnikova
International Journal of Machining and Machinability of Materials (IJMMM), Vol. 24, No. 1/2, 2022
Abstract: The ploughing forces (PFs) are one of the important parameters for calculating tool life. They directly affect the stress on the tool flank face and are responsible for the wear and tear conditions of the cutting tool as well. In this study we attempted to find the impact of cutting speed on PFs, that is, the relation between cutting speed and PFs. In this paper, PFs were estimated by a new comparison method in which forces at different points of contact are added (sum of the forces) to accurately measure the PFs. The PFs estimated with this method will be more accurate than previously used methods. This paper presents the measurement results of the PFs when turning stainless steel, structural steel and aluminium alloy materials. The results of experimental studies showed that an increase in cutting speed ranging from 50 to 200 m/min resulted in an increase in PFs by 1.4-3.2 times when turning with different flank wears.
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Machining and Machinability of Materials (IJMMM):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email subs@inderscience.com
Our Blog 
Follow us on Twitter 
Visit us on Facebook