Investigating the microstructure and morphology of chips in dry, flood coolant and MQL machining of Ti-6Al-4V alloy Online publication date: Mon, 04-May-2020
by Ashutosh Khatri; Muhammad P. Jahan
International Journal of Sustainable Manufacturing (IJSM), Vol. 4, No. 2/3/4, 2020
Abstract: The objective of this research is to investigate the morphology and microstructure of the chips formed during milling of Ti-6Al-4V alloy using conventional flood coolant and sustainable dry and MQL machining conditions. It was found that the chips formed in dry machining suffered a higher degree of serration indicating higher chip temperature and ineffective cooling of the chips. The bi-modal structure of Ti-6Al-4V remained the same in the bulk part of the chips. However, phase transformations were seen for all three machining conditions at the shearing plane of the chips. The chips formed in dry machining had comparatively higher percentage of β-phase due to phase transformation. For the chips obtained in flood coolant machining, the transformed β-phase possibly returned to martensitic α-phase due to rapid cooling. The MQL machined chips had the least transformation of β-phase, indicating minimal changes in mechanical properties of the machined parts in sustainable MQL machining.
Online publication date: Mon, 04-May-2020
Go to Inderscience Online Journals to access the Full Text of this article.
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Sustainable Manufacturing (IJSM):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email firstname.lastname@example.org