Study on the surface micro-topography in pre-stressed dry grinding process Online publication date: Sun, 14-Jan-2018
by Yansheng Deng; Xiaoliang Shi; Shichao Xiu; Minghe Liu
International Journal of Abrasive Technology (IJAT), Vol. 8, No. 2, 2017
Abstract: To study the surface micro-topography in pre-stressed dry grinding process, the single grain cutting simulations were carried out in DEFORM-3D, besides, dry grinding experiments were conducted. The residual stress, groove depth and pile-up height were analysed in the simulations. The surface roughness was measured, and micro-surface topography was observed by SEM in the experiments. The results indicated that the application of pre-stress is beneficial to generate more compressive stress, which is beneficial to restrain the generation of surface micro-cracks. Pre-stress can reduce the pile-up height. When pre-stress is within a lower range, the groove depth decreases with pre-stress increasing, however, once pre-stress overcomes a certain value, surface fold appears and surface roughness increases instead. The influence rules of the cutting depth and feeding speed on surface micro-topography in pre-stressed dry grinding process are consistent with them in the traditional grinding process.
Online publication date: Sun, 14-Jan-2018
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Abrasive Technology (IJAT):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email email@example.com