Characterisation and online monitoring of wear behaviour of on-machine fabricated PCD micro-tool while vertical micro-grinding of BK7 glass Online publication date: Tue, 30-Sep-2014
by Asma Perveen; Y.S. Wong; M. Rahman
International Journal of Abrasive Technology (IJAT), Vol. 4, No. 4, 2011
Abstract: This paper deals with the wear behaviour of polycrystalline diamond tool of 0.5 m grain size during micro-grinding of BK7 glass. It was found that tool wear caused both diameter and length reduction and G ratio was found to be 940. Observation of tool surface gave clear indication of edge chipping and abrasion type of tool wear where grain was pulled out and micro-cracks and built up edge mechanism are responsible for wear mode. Tool wear progress can be divided into three stages. In the initial stage, tool suffers insignificant wear, then intermediate wear, and finally, severe worn out tool. Huge pitting on bottom surface, chipped side wall, longer centre line and double side wall lining are the major phenomena of severe tool wear. Moreover, the increasing tendency of normal cutting force is found to support the evidence of tool blunting but cannot clearly indicate the severity of wear. Monitoring of root mean square acoustic emission signal is found to give an indication of tool topographic condition, i.e., sharpness and bluntness of cutting edge. Moreover, this signal can also envisage minor and major tool chipping condition. Hence, monitoring the AE signal can be a plausible way of monitoring PCD tool condition.
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Abrasive Technology (IJAT):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email subs@inderscience.com