Monitoring and prediction of tool wear in microturning of copper
by P. Ranjith Kumar, A.S.S. Balan, S. Gowri
International Journal of Precision Technology (IJPTECH), Vol. 1, No. 3/4, 2010

Abstract: This paper presents experimental results of microturning of commercially available copper rods with cermet (TiC + Al2O3) inserts as cutting tool. Machining was done in DT-110 integrated multiprocess micromachine tool. Full factorial experiments were conducted with various combinations of cutting speed, feed and depth of cut. Tool wears for different conditions were measured offline and also acoustic emission signals (AE rms) were recorded. Variations of tool wear with time and correlation between AE rms and tool wear were studied. Good correlation was observed between AE rms and tool wear. SEM images of worn tool shows fairly uniform structure around the cutting edge without any material erosion. Also crater wear was observed on the rake face with formation of a ledge. It was found that mostly steady machining can be obtained with medium speed and feed.

Online publication date: Tue, 16-Feb-2010

The full text of this article is only available to individual subscribers or to users at subscribing institutions.

 
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.

Pay per view:
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.

Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Precision Technology (IJPTECH):
Login with your Inderscience username and password:

    Username:        Password:         

Forgotten your password?


Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.

If you still need assistance, please email subs@inderscience.com