Defect control analysis for improving quality and productivity: an innovative Six Sigma case study Online publication date: Sat, 21-Feb-2015
by M. Shanmugaraja, M. Nataraj, N. Gunasekaran
International Journal of Quality and Innovation (IJQI), Vol. 1, No. 3, 2011
Abstract: This research study proposes an innovative analysis for controlling the defects in aluminium die casting industry. In this analysis, casting process of a two-stroke engine oil pump body is concentrated. The component selected has often rejected due to blow hole defects. Six Sigma, the zero defect approach, is used in this study. Define measure, analyse, improve and control (DMAIC) problem solving methodology is applied for problem analysis. Taguchi's experimental design is used for process validation and improvement. The confirmation experiment showed that the rejection rate was reduced to 4.8% from 17.22%. The application of Six Sigma program with Taguchi technique has developed an innovative cost effective methodology for controlling defects in die casting process in less experimental time.
Online publication date: Sat, 21-Feb-2015
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Quality and Innovation (IJQI):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email email@example.com