Improvement of the numerical modelling in orthogonal dry cutting of an AISI1045 steel by the introduction of a new friction model Online publication date: Tue, 30-Dec-2014
by C. Bonnet, J. Rech, H. Hamdi, E. D'Eramo
International Journal of Machining and Machinability of Materials (IJMMM), Vol. 9, No. 3/4, 2011
Abstract: The numerical modelling of cutting processes remains an issue for scientists. A better understanding of friction modelling is required to lead to more realistic finite element models (FEMs). This work proposes to evaluate the performance of a new friction model depending on the local sliding velocity. This model has been applied to the investigation of an AISI1045 steel in dry orthogonal cutting. The friction model has been implemented in a FEM based on the Arbitrary Lagrangian-Eulerian (ALE) approach. A large spectrum of cutting velocities and feed rates has been investigated. In parallel, experimental orthogonal cutting test have been performed in order to evaluate the accuracy of the model for each cutting condition. The model has shown a very good agreement with experimental results.
Online publication date: Tue, 30-Dec-2014
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Machining and Machinability of Materials (IJMMM):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email email@example.com