Taguchi robust design for multiresponse drilling optimisation to minimise burr size using utility concept Online publication date: Sat, 21-Jul-2007
by V.N. Gaitonde, S.R. Karnik
International Journal of Manufacturing Research (IJMR), Vol. 2, No. 2, 2007
Abstract: In the present study, a multiresponse optimisation method using the Taguchi robust design approach and the utility concept is proposed for the simultaneous minimisation of burr height and burr thickness in the drilling of AISI 1018 steel. The experiments were planned as per Taguchi's L25 orthogonal array with each experiment performed under different conditions of cutting speed, feed, point angle and lip clearance angle for a 6 mm drill diameter. In the utility concept for multiresponse optimisation, the multiresponse signal-to-noise ratio for each trial in the array is determined by employing the weighting factors for burr height and burr thickness. The Analysis of Variance (ANOVA) was employed to identify the level of importance of the machining parameters on burr size. A detailed analysis of ANOVA with the different combinations of the weighting factors to determine the contributions of various parameters in controlling the burr size is presented.
Online publication date: Sat, 21-Jul-2007
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Manufacturing Research (IJMR):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email firstname.lastname@example.org