Deformation behaviour of A356, Al-11Si-2.5Cu-0.6Fe, and Al-18Si-2.5Cu-0.6Fe alloys forged under different processing conditions Online publication date: Fri, 22-Feb-2019
by Khemraj; A.K. Jha; S.N. Ojha
International Journal of Materials Engineering Innovation (IJMATEI), Vol. 10, No. 1, 2019
Abstract: The present paper aims to investigate the feasibility of bulk processing of Al-Si alloys under different processing temperatures. Three different compositions of Al-Si alloys (namely A356, Al-11Si-2.5Cu-0.6Fe, and Al-18Si-2.5Cu-0.6Fe) have been forged between flat die platen at 300 and 500°C processing temperatures. High-speed forging was performed with the help of power hammer. The results obtained are discussed critically to illustrate the interaction of various processing parameters associated with the processing of the alloys. The results reveal severe crack generation on the outer periphery of forged billets, while it reduced with low amount of silicon in the alloy. During processing, microstructural refinement and improvement in the mechanical properties were observed. The present work provides valuable insight into producing complex formed products of Al-Si alloys for extensive industrial applications.
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Materials Engineering Innovation (IJMATEI):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email subs@inderscience.com