Dynamic analysis of a front-end accessory drive with a decoupler/isolator Online publication date: Wed, 21-Dec-2005
by Raghavan Balaji, Eric M. Mockensturm
International Journal of Vehicle Design (IJVD), Vol. 39, No. 3, 2005
Abstract: In automotive front-end accessory drives (FEAD), the crankshaft supplies power to accessories like alternators, pumps, etc. When the FEAD undergoes forced vibration due to crankshaft excitation, dynamic tension fluctuations can cause the belt to slip on the accessory pulleys. In this paper, an accessory inertia (e.g. alternator) is isolated/separated from the FEAD by placing between the pulley and accessory a combination of a one-way rigid clutch and an isolator spring. The rotational response of a typical FEAD is extended to include this decoupler-isolator. Analytical solutions are obtained by considering it as a piecewise-linearised system about the equilibrium angular displacements. The tension fluctuation of the ordinary FEAD is then compared to that of the system with a decoupler/isolator. The results indicate that within the practical working range of engine speeds, use of either an isolator or a decoupler-isolator could significantly lower the dynamic tension drop across the accessory pulley.
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Vehicle Design (IJVD):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email subs@inderscience.com
Our Blog 
Follow us on Twitter 
Visit us on Facebook