An experimental study of response surface methodology to optimise the operating parameters on PEM fuel cell Online publication date: Fri, 02-Sep-2016
by Elif Eker Kahveci; Imdat Taymaz
International Journal of Vehicle Design (IJVD), Vol. 71, No. 1/2/3/4, 2016
Abstract: In this study, the effects of hydrogen flow rate, oxygen flow rate, cell and humidification temperature on power density were examined experimentally. The experiments have been carried out on a single proton exchange membrane (PEM) fuel cell with the active area of 25 cm². Response surface methodology (RSM) was used to determine the optimum conditions of PEM fuel cell by Design-Expert 8.0 (trial version). It was found that temperature had an important effect on the performance of PEM fuel cell by the results of experiments. Increasing both cell and humidification temperature increased the performance of the fuel cell system. Even cell performance decreases after exceeding a definite temperature. An increase occurred in performance at low cell potential with increasing the hydrogen flow rates. And, maximum power density, whose value was 0.5495 mW/m², was reached at these conditions of 0.4 V, 5 L/min hydrogen flow rate, 70°C humidification temperatures and 40°C cell temperatures.
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Vehicle Design (IJVD):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email subs@inderscience.com