Workpiece surface integrity and productivity when cutting CFRP and GFRP composites using a CO₂ laser
by I.S. Shyha; Chun-Liang Kuo; S.L. Soo
International Journal of Mechatronics and Manufacturing Systems (IJMMS), Vol. 7, No. 2/3, 2014

Abstract: Following a brief literature review, results from tests involving laser cutting of carbon and glass fibre reinforced plastic (CFRP and GFRP) composites are presented. The influence of cutting speed, laser beam power and gas pressure on material removal rate (MRR), kerf width and workpiece surface integrity were investigated. Productivity was up to ~100% higher when cutting GFRP compared to CFRP, with a maximum MRR of ~8 cm³/min achieved when operating at a cutting speed of 1750 mm/min, 2500 W beam power and gas pressure of 5 bar. Charring and melting of the matrix phase was observed in both materials and similarly surface voids/cavities were evident on the CFRP and GFRP samples. Three-dimensional topographic maps also revealed the presence of grooves on the latter, which would explain the significantly higher surface roughness levels obtained (up to ~13µm Ra). Heat affected zones were visible in the majority of CFRP specimens assessed which extended to a depth of ~1.5mm (depending on the fibre orientation) while only minor damage in terms of fibre protrusion was apparent in corresponding GFRP workpieces. Kerf widths decreased with increasing cutting speed and were typically over 2 times larger in the GFRP material.

Online publication date: Tue, 21-Oct-2014

The full text of this article is only available to individual subscribers or to users at subscribing institutions.

 
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.

Pay per view:
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.

Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Mechatronics and Manufacturing Systems (IJMMS):
Login with your Inderscience username and password:

Username:        Password:          Forgotten your password?

Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.

If you still need assistance, please email subs@inderscience.com