Three-axle buses: a solution for reducing axle load
by A. Kiraly
International Journal of Vehicle Design (IJVD), Vol. 11, No. 4/5, 1990

Abstract: The need to reduce axle load has led to the increasing use of the third axle on buses and coaches. Disadvantages include extra cost, higher operating and maintenance costs, and increased noise. Various methods of installing the third axle are discussed. Technical problems involved in installing the third axle include: finding an optimum steering angle, wheelbase, rear and front overhang and wheelbase for the double axle; finding the optimal axle-load distribution; calculating the modified load distribution for the frame, the extra load on the frame when the trailer axle is unloaded; and controlling the air pressure in the air springs. Simplified two-axle and three-axle models in the form of a lattice-type frame were used to simulate the bending moment distribution. Results show that, by using the third axle, maximum bending decreases on the sidewalls and longitudinal members of the frame.

Online publication date: Mon, 26-May-2014

The full text of this article is only available to individual subscribers or to users at subscribing institutions.

 
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.

Pay per view:
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.

Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Vehicle Design (IJVD):
Login with your Inderscience username and password:

Username:        Password:          Forgotten your password?

Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.

If you still need assistance, please email subs@inderscience.com