Investigation on the machinability of steel/steel laminates by CO₂ laser
by Mehmet Şimşir; Ali Özer; Levent Cenk Kumruoğlu
International Journal of Materials and Product Technology (IJMPT), Vol. 48, No. 1/2/3/4, 2014

Abstract: In this study, an experimental investigation of machinability of steel/steel laminates using CO₂ laser was presented. O₂ assist gas was used for cutting of laminates. Laser power and feed rate were changed gradually as cutting parameters. Heat affected zone (HAZ) size and kerf width were measured. Effect of linear energy density (ratio of power to feed rate) was determined on the kerf width, the HAZ size, and the cutting surface quality. Also, the quality of surface was examined under optical microscopy, and scanning electron microscopy. It is concluded that when linear energy density is increased, the kerf width and the HAZ size increase. Dross formation and surface irregularities increase with increasing laser power and decreasing feed rate.

Online publication date: Fri, 30-May-2014

The full text of this article is only available to individual subscribers or to users at subscribing institutions.

 
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.

Pay per view:
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.

Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Materials and Product Technology (IJMPT):
Login with your Inderscience username and password:

Username:        Password:          Forgotten your password?

Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.

If you still need assistance, please email subs@inderscience.com