Modelling and experimental study of chip serration frequency in dry turning of Ti-6Al-4V alloy
by Vikas Upadhyay; P.K. Jain; N.K. Mehta
International Journal of Machining and Machinability of Materials (IJMMM), Vol. 12, No. 4, 2012

Abstract: This paper presents the investigation on the effects of cutting speed, feed rate and depth of cut on chip serration frequency in dry turning of Ti-6Al-4V alloy. The chip serration frequency plays a vital role in determining the machinability of this alloy as the serrated chips are observed at low cutting speed. Serrated chip formation causes a cyclic variation of cutting forces and often leads to serious vibrations resulting in chatter. The chip serration frequency is calculated by the distance between two consecutive shearing planes. Using the results of experiments, a regression model has been developed for chip serration frequency. Based on analysis of variance at 95% confidence interval the model is found to be highly significant. Cutting speed is found to be the most significant factor affecting the chip serration frequency. The effect of feed rate is much less and that of the depth of cut is insignificant.

Online publication date: Sat, 23-Aug-2014

The full text of this article is only available to individual subscribers or to users at subscribing institutions.

 
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.

Pay per view:
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.

Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Machining and Machinability of Materials (IJMMM):
Login with your Inderscience username and password:

    Username:        Password:         

Forgotten your password?


Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.

If you still need assistance, please email subs@inderscience.com