Experimental study and empirical modelling of magnetic abrasive finishing on ferromagnetic and non-ferromagnetic materials
by V.K. Jain; Vinod Kumar; M. Ravi Sankar
International Journal of Precision Technology (IJPTECH), Vol. 3, No. 1, 2012

Abstract: Magnetic abrasive finishing is one of the advanced finishing processes where in the iron (Fe) particles form a flexible matrix in which the abrasives are trapped when magnetic field is applied. In the present paper, the magnetic flux densities (MFD) are measured at various distances from the outer surface to centre on ferromagnetic and non-ferromagnetic materials with approximately same hardness. MFD is about three times higher on ferromagnetic compared to non-ferromagnetic workpiece. Complete experimental study is carried out and empirically modelled. Best final Ra value about 20 nm and 60 nm is achieved on ferromagnetic and non-ferromagnetic stainless steel, respectively. With increase in abrasive mesh size and decrease in working gap, percentage change in Ra (%ΔRa) increases. Online measurement of forces is done using indigenously developed ring type dynamometer. Normal magnetic force is much higher in case of ferromagnetic than non-ferromagnetic workpiece material but no significant change is found in tangential cutting force.

Online publication date: Wed, 22-Apr-2015

The full text of this article is only available to individual subscribers or to users at subscribing institutions.

 
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.

Pay per view:
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.

Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Precision Technology (IJPTECH):
Login with your Inderscience username and password:

    Username:        Password:         

Forgotten your password?


Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.

If you still need assistance, please email subs@inderscience.com