Application of the plastic region fastening method to the production line
by M. Katayose, Y. Sasaki
International Journal of Materials and Product Technology (IJMPT), Vol. 6, No. 1, 1991

Abstract: The plastic region fastening method is superior to the torque method. However, it has not been introduced into production lines because of the lack of an appropriate control technique and positive quality control. With a view to introducing the plastic region fastening method into production lines, appropriate fastening control was investigated. Finally, both the angle method with a range of compensation and a quality control method based on detection of the yield point were established. They are currently being used by Toyota on many of their engine parts.

Online publication date: Fri, 05-Nov-2010

The full text of this article is only available to individual subscribers or to users at subscribing institutions.

 
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.

Pay per view:
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.

Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Materials and Product Technology (IJMPT):
Login with your Inderscience username and password:

Username:        Password:          Forgotten your password?

Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.

If you still need assistance, please email subs@inderscience.com