Production of rubber pads by tyre recycling Online publication date: Tue, 24-Mar-2009
by Alessandro Guglielmotti, Carmine Lucignano, Fabrizio Quadrini
International Journal of Materials Engineering Innovation (IJMATEI), Vol. 1, No. 1, 2009
Abstract: Tyre recycling is a social problem but it may be a profitable operation if valid industrial applications would be experimented. In this study, the authors suggest that the combination of powder comminution and compression moulding of powders is an efficient solution to produce large rubber pads with good mechanical properties. An experimental approach is reported to design a 'direct powder moulding' (in absence of virgin rubber or linking agent). Small samples were moulded in stainless steel moulds to evaluate the mechanical performances. Good results were obtained even if medium size particles are directly moulded, whereas the existing scientific contributions only deal with fine particles. Large pads were moulded in an aluminium mould to reduce cycle time. Due to the technical limits, the moulding pressure was reduced and this occurrence limited the final performances of the rubber pad. Nevertheless, the final properties are high enough to allow structural and functional applications.
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Materials Engineering Innovation (IJMATEI):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email subs@inderscience.com