Numerical simulation of coolant mixing in a pressurised water reactor with different CFD methods based on complex meshes Online publication date: Wed, 06-Feb-2008
by Thomas Hoehne
International Journal of Nuclear Energy Science and Technology (IJNEST), Vol. 3, No. 4, 2007
Abstract: This paper describes the numerical simulation of coolant mixing in the downcomer and the lower plenum of the Rossendorf test facility, ROCOM. ROCOM is a 1:5 scale Plexiglas model of a German pressurised water reactor, allowing conductivity measurements by wire mesh sensors and velocity measurements by the LDA technique. The CFD calculations were carried out with the CFD codes CFX-4 and CFX-5. In the case of stationary mixing, the maximum value of the averaged mixing scalar at the core inlet was found in the sector below the inlet nozzle, where the tracer was injected. The comparison of a very detailed mesh (CFX-5) and a mesh with simplifications and additional physical models (CFX-4) showed that in the referred case, the use of these models are allowed. For turbulent flows, CFX-4 and CFX-5 were validated in accordance with the Best Practice Guidelines and can be used in the reactor safety analysis. A better description of the mixing processes inside the RPV is the basis of a more realistic safety assessment.
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Nuclear Energy Science and Technology (IJNEST):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email subs@inderscience.com
Our Blog 
Follow us on Twitter 
Visit us on Facebook