Effect of drilling parameters on mechanical strength in drilling glass fibre reinforced plastic Online publication date: Tue, 06-Feb-2007
by V. Krishnaraj, S. Vijayarangan, A. Ramesh Kumar
International Journal of Computer Applications in Technology (IJCAT), Vol. 28, No. 1, 2007
Abstract: The damage generated during the drilling of Glass Fibre Reinforced Plastics (GFRP) is detrimental for the mechanical behaviour of the composite structure. This work is focused on analysing the influence of drilling parameters (spindle speed and feed) on the strength of the GFR woven fabric laminates and further to study the residual stress distribution around the hole after drilling. Holes were drilled at the centre of the specimens in a CNC machining centre using 6 mm diameter micrograin carbide drill for various spindle speeds (1000–4000 rpm) and feed rates (0.02, 0.06, 0.10 and 0.20 rev/min). Degree of damage depends on the feed rate and spindle speed. Experimental results indicate that failure strength and stress concentration are related to the drilling parameters and a drilling parameter (3000 rpm and 0.02 mm/rev), which gives better mechanical strength.
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Computer Applications in Technology (IJCAT):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email subs@inderscience.com