An experimental investigation of element diffusion and mechanical properties of solid WC/Co carbide tool in high-speed milling Ti6Al4V Online publication date: Sun, 27-Sep-2015
by Yujing Sun; Jie Sun; Jianfeng Li
International Journal of Machining and Machinability of Materials (IJMMM), Vol. 17, No. 3/4, 2015
Abstract: During high-speed milling Ti6Al4V, the diffusion process is produced under the actions of high temperature, high pressure at the tool-chip interface, and the differences of the concentrations and diffusion coefficients of various elements of tool and workpiece. In this study, dry end milling tests on Ti6Al4V were carried out with solid WC/Co carbide tool. The Vickers hardness of tool near and far away from the rake face boundary of a circumferential cutting edge, regarded as diffusion interface, was measured. The element removing of tungsten (W), carbon (C), and cobalt (Co) of WC/Co carbide tool was examined by the energy dispersive spectroscopy (EDS). And the relationship between element diffusion and the variation of mechanical properties of WC/Co carbide tool was discussed. The results showed that the decohesion and removing of the tungsten carbide (WC) and cobalt (Co) particles due to diffusion leaded to the change of mechanical properties of the WC/Co carbide tool, which may contribute to more severe tool wear.
Online publication date: Sun, 27-Sep-2015
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Machining and Machinability of Materials (IJMMM):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email firstname.lastname@example.org