The full text of this article

 

A measurement system with contour tracking for repair of components
by Yangsheng Li; Lijue Xue
International Journal of Manufacturing Research (IJMR), Vol. 7, No. 1, 2012

 

Abstract: The repair of worn-out components requires the extraction of their actual geometry. To acquire the surface contour, a laser displacement sensor and a CNC motion system are typically used. One of the factors that affect the measuring accuracy is the sensor 's resolution. A high resolution sensor usually has a short measuring range. Therefore, a contour with a large peak-to-valley height cannot usually be measured using a short range sensor. In this research, a measurement system of tracking target surface was developed. The proposed measurement system has been used for repair of worn-out components using laser cladding. [Received 6 May 2011; Revised 2 September 2011; Accepted 5 September 2011]

Online publication date: Wed, 01-Feb-2012

 

is only available to individual subscribers or to users at subscribing institutions.

 
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.

 
Pay per view:
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.

 
Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Manufacturing Research (IJMR):
Login with your Inderscience username and password:

 

    Username:        Password:         

Forgotten your password?


 
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.

 
If you still need assistance, please email subs@inderscience.com