The full text of this article

 

Establishment of a measuring station on a diamond turning machine for in-process cutting edge inspection of single point diamond micro-tools
by SungHo Jang; Takemi Asai; Yuki Shimizu; Wei Gao
International Journal of Nanomanufacturing (IJNM), Vol. 8, No. 1/2, 2012

 

Abstract: This paper presents a measuring station based on an atomic force microscope (AFM), which is designed and constructed on a four-axis diamond turning machine for inspection of the cutting edge profile of single point diamond micro-tools. The measuring station is composed of an AFM probe unit for three-dimensional (3D) edge profile measurement and an alignment system with an optical sensor for aligning the probe-tip with the edge top of the tool chip. The alignment system greatly shortens the alignment time, which is essential for carrying out the edge profile measurement by the AFM. Measurement experiments of round nose micro-tools with nominal nose radii of 8 µm and less than 2 µm were carried out to demonstrate the performance of the measuring station.

Online publication date: Sun, 01-Jan-2012

 

is only available to individual subscribers or to users at subscribing institutions.

 
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.

 
Pay per view:
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.

 
Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Nanomanufacturing (IJNM):
Login with your Inderscience username and password:

 

    Username:        Password:         

Forgotten your password?


 
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.

 
If you still need assistance, please email subs@inderscience.com