The full text of this article

 

Influence of glycerin-air dielectric medium on near-dry EDM of titanium alloy
by Krishnakant Dhakar; Akshay Dvivedi
International Journal of Additive and Subtractive Materials Manufacturing (IJASMM), Vol. 1, No. 3/4, 2017

 

Abstract: Ti-6Al-4V is one of the most commonly used titanium alloy. The applications involve in the area of aerospace, chemical engineering, biomedical implants, marine industries, etc. The electrical discharge machining (EDM) is an unconventional machining process. It is widely used to produce complex profiles on electrically conductive materials. Near-dry EDM is a process variant of the EDM process. Generally, it uses water-air mixture as a dielectric medium. Near-dry EDM is an environment friendly process. In this investigation near-dry EDM of Ti-6AL-4V was investigated with glycerin-air dielectric medium. The one-factor-at-a-time approach was used for experimentation. The process parameters selected for experimentation were current, duty factor, lift setting, sensitivity setting, flushing pressure, liquid flow rate and gap control. The responses measured were material removal rate (MRR) and surface roughness (SR). The experimental results revealed that glycerin-air dielectric medium produced higher MRR with fine surface finish even at higher current and wear ratio of the process was also less than 1%.

 

is only available to individual subscribers or to users at subscribing institutions.

 

Existing subscribers:

Go to Inderscience Online Journals to access the full text.

 

Pay per view:

If you are not a subscriber and you just want to read the full contents of this article, buy online access here.

 
Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Additive and Subtractive Materials Manufacturing (IJASMM):
Login with your Inderscience username and password:

 

    Username:        Password:         

Forgotten your password?


 

Want to subscribe?

A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.

 

If you still need assistance, please email subs@inderscience.com