International Journal of Machining and Machinability of Materials (IJMMM)

International Journal of Machining and Machinability of Materials

2016 Vol.18 No.5/6

Special Issue on Enhancing the Performance of Traditional Machining

Guest Editors: Dr. Uday S. Dixit and Dr. Manas Das

Editorial

Pages Title and author(s)
452-465Experimental assessment on performance of TiN/TiCN/Al2O3/ZrCN coated tool during dry machining of Nimonic C-263
Aruna Thakur; Soumya Gangopadhyay; Aveek Mohanty; Kalipada Maity
DOI: 10.1504/IJMMM.2016.078985
466-482Comparative evaluations of nose wear progression and failure modes during hard turning under dry and near-dry cutting conditions
Satish Chinchanikar; S.K. Choudhury
DOI: 10.1504/IJMMM.2016.078991
483-500Effect of tool wear on white layer thickness and subsurface hardness on hard turned EN31 steel
Gaurav Bartarya; S.K. Choudhury
DOI: 10.1504/IJMMM.2016.078993
501-521Experimental investigation on cutting force and surface roughness in machining of hardened AISI 52100 steel using cBN tool
Sudhansu Ranjan Das; Amaresh Kumar; Debabrata Dhupal
DOI: 10.1504/IJMMM.2016.078997
522-539Experimental comparative study of conventional, micro-textured and coated micro-textured tools during machining of hardened AISI 1040 alloy steel
Kishor Kumar Gajrani; Rokkham Pavan Kumar Reddy; M. Ravi Sankar
DOI: 10.1504/IJMMM.2016.078982
540-551An experimental study of cutting forces and temperature in multi-tool turning of grey cast iron
R. Kalidasan; M. Yatin; D.K. Sarma; S. Senthilvelan; U.S. Dixit
DOI: 10.1504/IJMMM.2016.078992
552-571Determining cutting force coefficients from instantaneous cutting forces in ball end milling
Mithilesh K. Dikshit; Asit Baran Puri; Atanu Maity; Amit Jyoti Banarjee
DOI: 10.1504/IJMMM.2016.078984
572-585Effect of process parameters on convective heat transfer coefficient of fluid and heat partitioning in high efficiency deep grinding with water-based coolant
M. Vashista; S. Paul
DOI: 10.1504/IJMMM.2016.078994
586-605An alternate method for optimisation of minimum quantity lubrication parameters in surface grinding
Manoj Kumar Sinha; Dinesh Setti; Sudarsan Ghosh; P. Venkateswara Rao
DOI: 10.1504/IJMMM.2016.078983

Additional Papers

606-620Study on fluctuation of cutting force in process of high-speed milling of Inconel 718
Wenjie Zhang
DOI: 10.1504/IJMMM.2016.078975
621-633Study of the local forces along a cutting edge when drilling Ti6Al4V - comparison of methods
Antoine Poutord; Frédéric Rossi; Gérard Poulachon; Rachid M'Saoubi; Guillaume Abrivard
DOI: 10.1504/IJMMM.2016.078976
634-647Study of finish milling of titanium alloy (TI6AL4V)
V. Krishnaraj; B. Hari Krishna; Jamal Y. Sheikh-Ahmad
DOI: 10.1504/IJMMM.2016.078981

 

Return to top