| Pages | Title and authors |
| 133-147 | Polish-mirror finish surfaces obtained by high precision turning
Alexis Gautier, Hatem Khanfir, Philippe Revel, Rene-Yves Fillit
DOI: 10.1504/IJMMM.2008.023190 |
| 148-157 | A numerical study of phase transformation during grinding
Alexandre Brosse, Hedi Hamdi, Jean Michel Bergheau
DOI: 10.1504/IJMMM.2008.023191 |
| 158-180 | Surface profile prediction and analysis applied to turning process
Chen Lu, Jean-Philippe Costes
DOI: 10.1504/IJMMM.2008.023192 |
| 181-194 | Residual stress analysis in Inconel 718 milled turbine disk
Mario Lavella, Teresa Berruti, Enrica Bosco
DOI: 10.1504/IJMMM.2008.023193 |
| 195-216 | Effect of shot peening parameters on the surface integrity of 316L material
S.B. Mahagaonkar, P.K. Brahmankar, C.Y. Seemikeri
DOI: 10.1504/IJMMM.2008.023194 |
| 217-236 | Experimental investigation to predict the condition of cutting tool by surface texture analysis of images of machined surfaces based on amplitude parameters
B.S. Prasad, M.M.M. Sarcar
DOI: 10.1504/IJMMM.2008.023206 |
| 237-251 | Some studies on design and performance analysis of a new low plasticity burnishing tool
C.Y. Seemikeri, P.K. Brahmankar, S.B. Mahagaonkar
DOI: 10.1504/IJMMM.2008.023195 |
| 252-274 | Effect of SiC powder-suspended dielectric fluid on the surface finish of 6061Al/Al2O3P/20p composites
during electric discharge machining
Shankar Singh, Sachin Maheshwari, Poorn Chandra Pandey
DOI: 10.1504/IJMMM.2008.023196 |
| 275-286 | A new approach for the modelling of residual stresses induced by turning of 316L austenitic stainless steel
Frederic Valiorgue, Joel Rech, Hedi Hamdi, Philippe Gilles, Jean Michel Bergheau
DOI: 10.1504/IJMMM.2008.023197 |
Editorial