International Journal of Machining and Machinability of Materials (IJMMM)

International Journal of Machining and Machinability of Materials

2008 Vol.3 No.3/4

Special Issue on Advances In Machining of Composites Materials II

Editor: Prof. J. Paulo Davim

Editorial

Pages Title and author(s)
226-240EDM machinability and frictional behaviour of ZrO2-TiCN composites
Koenraad Bonny, Patrick De Baets, Jozef Vleugels, Arezou Salehi, Omer Van der Biest, Bert Lauwers, Weidong Liu
DOI: 10.1504/IJMMM.2008.020960
241-251Effect of tool wear progression on cutting forces and surface quality during cutting metal matrix composites
S. Kannan, H.A. Kishawy
DOI: 10.1504/IJMMM.2008.020961
252-271Modelling the machinability of self-lubricated aluminium/alumina/graphite hybrid composites using a fuzzy subtractive clustering-based system identification method
Mohammed T. Hayajneh, Adel Mahmood Hassan
DOI: 10.1504/IJMMM.2008.020962
272-282Electrodischarge drilling of microholes in aluminium matrix composites
Dionizy Bialo, Jan Peronczyk
DOI: 10.1504/IJMMM.2008.020963
283-292Surface characteristics of Al-(SiC)p metal matrix composites by roller burnishing process
E. Shankar, M.R. Stalin John, M. Thirumurugan, B. Mohan
DOI: 10.1504/IJMMM.2008.020964
293-308Experimental investigation and optimisation in EDM of Al 6063 SiCp metal matrix composite
Akshay Dvivedi, Pradeep Kumar, Inderdeep Singh
DOI: 10.1504/IJMMM.2008.020965
309-325Study into causes of damage to carbon epoxy composite material during the drilling process
Pierre Rahme, Yann Landon, Pierre Lagarrigue, Frederic Lachaud, Robert Piquet
DOI: 10.1504/IJMMM.2008.020966
326-342Experimental and analytical study of the influence of HexFit® glass fibre composite manufacturing process on delamination during drilling
Redouane Zitoune, Francis Collombet, Guillermo Hernaiz Lopez
DOI: 10.1504/IJMMM.2008.020967
343-355Drilling of e-glass fibre reinforced polymer composite
Alakesh Manna, Vivek Mohindra, Suprakash Patra, Sandeep M. Salodkar
DOI: 10.1504/IJMMM.2008.020968
356-363Experimental investigation on drilling temperature of composites
Yanming Quan, Luhua Sun
DOI: 10.1504/IJMMM.2008.020969
364-381Experimental investigation on machining of filament wound GFRP pipe by cemented carbide (K20) cutting tool
A. Naveen Sait, A. Noorul Haq, S. Aravindan
DOI: 10.1504/IJMMM.2008.020971
382-402Optimisation of surface finish in abrasive water jet cutting of Kevlar composites using hybrid Taguchi and response surface method
Tauseef Uddin Siddiqui, Mukul Shukla, Pankaj B. Tambe
DOI: 10.1504/IJMMM.2008.020970