Title: Development of control strategies of a multi-wheeled combat vehicle

Authors: Peter D'Urso; Moustafa El-Gindy

Addresses: Department of Automotive, Mechanical and Manufacturing, Faculty of Engineering and Applied Science, University of Ontario Institute of Technology, 2000 Simcoe Street North, Oshawa, Ontario, L1H 7k4, Canada ' Department of Automotive, Mechanical and Manufacturing, Faculty of Engineering and Applied Science, University of Ontario Institute of Technology, 2000 Simcoe Street North, Oshawa, Ontario, L1H 7k4, Canada

Abstract: This work develops a vehicle dynamics controller for vehicle stability, manoeuvrability and turning circle reduction for an 8 × 8 heavy combat vehicle utilising both torque vectoring and third and fourth axle steering. The proposed control scheme is composed of two distinct controllers, each with their own range of operation based on vehicle speed. A feedforward zero side slip (ZSS) controller actuates the third and fourth axle steering angles. It is used for manoeuvring at speeds of 30 kph and below and for turning circle reduction. A two degrees of freedom (DOF) linear parameter varying (LPV) H controller that monitors steering wheel angle and yaw rate error and uses both the rear axle steering and torque vectoring to enhance vehicle stability and manoeuvrability at speeds above 40 kph. Gaussian distribution functions are used to switch from one controller to the other. The proposed control scheme is evaluated by running simulations using a validated computer simulation (TruckSim) full vehicle model in co-simulation with the controller and developed electric powertrain in Simulink. The proposed control system is able to greatly improve vehicle stability and manoeuvrability. A turning circle reduction of 30% is obtained using the ZSS feedforward method.

Keywords: torque vectoring; rear wheel steering; H; linear parameter varying; LPV; vehicle dynamics control; stability control; multi-wheeled combat vehicle; direct yaw moment control.

DOI: 10.1504/IJAAC.2018.092849

International Journal of Automation and Control, 2018 Vol.12 No.3, pp.325 - 360

Received: 08 Dec 2016
Accepted: 03 Mar 2017

Published online: 01 Jul 2018 *

Full-text access for editors Full-text access for subscribers Purchase this article Comment on this article