Title: Brake system performance requirements of a lightweight electric/hybrid rear wheel drive vehicle

Authors: J.T. Bray, G.R. Walker, A.G. Simpson, M.C. Greaves, B.D.Guymer

Addresses: Sustainable Energy Research Group, School of Information Technology and Electrical Engineering, University of Queensland, 4072, Australia. ' Sustainable Energy Research Group, School of Information Technology and Electrical Engineering, University of Queensland, 4072, Australia. ' Sustainable Energy Research Group, School of Information Technology and Electrical Engineering, University of Queensland, 4072, Australia. ' Sustainable Energy Research Group, School of Information Technology and Electrical Engineering, University of Queensland, 4072, Australia. ' Sustainable Energy Research Group, School of Information Technology and Electrical Engineering, University of Queensland, 4072, Australia

Abstract: This paper investigates the braking performance requirements of the UltraCommuter, a lightweight series hybrid electric vehicle currently under development at the University of Queensland. With a predicted vehicle mass of 600 kg and two in-wheel motors each capable of 500 Nm of peak torque, decelerations up to 0.46 g are theoretically possible using purely regenerative braking. With 99% of braking demands less than 0.35 g, essentially all braking can be regenerative. The wheel motors have sufficient peak torque capability to lock the rear wheels in combination with front axle braking, eliminating the need for friction braking at the rear. Emergency braking levels approaching 1 g are achieved by supplementation with front disk brakes. This paper presents equations describing the peak front and rear axle braking forces which occur under straight line braking, including gradients. Conventionally, to guarantee stability, mechanical front/rear proportioning of braking effort ensures that the front axle locks first. In this application, all braking is initially regenerative at the rear, and an adaptive ||by-wire|| proportioning system presented ensures this stability requirement is still satisfied. Front wheel drive and all wheel drive systems are also discussed. Finally, peak and continuous performance measures, not commonly provided for friction brakes, are derived for the UltraCommuter|s motor capability and range of operation.

Keywords: regenerative braking; wheel motors; electric vehicle; friction braking; peak performance; continuous performance; rear wheel drive; lightweight vehicles.

DOI: 10.1504/IJVAS.2003.004382

International Journal of Vehicle Autonomous Systems, 2003 Vol.1 No.3/4, pp.436 - 448

Published online: 10 May 2004 *

Full-text access for editors Full-text access for subscribers Purchase this article Comment on this article