Title: Impact of surface roughness of diamond coatings on the cutting performance when dry machining of graphite

Authors: Gil Cabral, P. Reis, E. Titus, J.C. Madaleno, J.P. Davim, J. Gracio, Waqar Ahmed, Mark J. Jackson

Addresses: Department of Mechanical Engineering, Centre for Mechanical Technology and Automation, University of Aveiro, Aveiro, Portugal. ' Department of Mechanical Engineering, Centre for Mechanical Technology and Automation, University of Aveiro, Aveiro, Portugal. ' Department of Mechanical Engineering, Centre for Mechanical Technology and Automation, University of Aveiro, Aveiro, Portugal. ' Department of Mechanical Engineering, Centre for Mechanical Technology and Automation, University of Aveiro, Aveiro, Portugal. ' Department of Mechanical Engineering, Centre for Mechanical Technology and Automation, University of Aveiro, Aveiro, Portugal. ' Department of Mechanical Engineering, Centre for Mechanical Technology and Automation, University of Aveiro, Aveiro, Portugal. ' School of Computing, Technology, and Physical Sciences, University of Central Lancashire, Preston PR1 4HE, UK. ' College of Technology, Centre for Advanced Manufacturing, Purdue University, West Lafayette IN 47907-2021, USA

Abstract: Time Modulated Chemical Vapour Deposition (TMCVD) process regime has been used to deposit diamond coatings onto commercially available tungsten carbide tool inserts. The TMCVD process was developed in our laboratories so that diamond films with fine grains could be deposited. It accomplishes this by promoting secondary nucleation during larger methane flow modulations. The average surface roughness of the diamond coatings were correlated with the cutting performance of the coatings when dry machining of graphite. Inserts coated were characterised by Scanning Electron Microscopy (SEM) and Raman spectroscopy and were tested for turning performance using graphite as the workpiece material. The cutting forces were measured by the DynoWareT™ data acquisition system. Polycrystalline Diamond (PCD) inserts were also used for comparison. Repeated turning tests showed that the surface roughness of the coatings is a limiting factor when achieving better chip flow during machining.

Keywords: graphite machining; surface roughness; diamond coatings; cutting performance; dry machining; cutting tools; advanced manufacturing; time modulated CVD; chemical vapour deposition; tungsten carbide; tool inserts.

DOI: 10.1504/IJMTM.2008.019655

International Journal of Manufacturing Technology and Management, 2008 Vol.15 No.2, pp.121 - 152

Published online: 18 Jul 2008 *

Full-text access for editors Full-text access for subscribers Purchase this article Comment on this article